Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 274 (HVAC CONTROL SYSTEM - GENERAL INFORMATION & DIAGNOSTICS)SPECIFICATIONSGENERAL SPECIFICATIONS
2010 Mercury Mariner Hybrid, AWD
General Specifications
2010 Mercury Mariner Hybrid, AWDSECTION General Specifications
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS
| Item | Specification | ||
|---|---|---|---|
| A/C Compressor | |||
| Type | FS18 | ||
| Displacement | 180 cc (11 cu in) | ||
| A/C Pressure Relief Valve (1) | |||
| Open pressures | 3,432-4,138 kPa (498-600 psi) | ||
| A/C Pressure Sensor | INTRODUCTION -- GASOLINE MODELS | ||
| Evaporator Core Orifice | |||
| Color | Orange | ||
| Diameter | 1.45 mm (0.057 in) | ||
| Magnetic Clutch | |||
| Air gap clearance | 0.35-0.65 mm (0.014-0.026 in) | ||
| A/C Cycling Switch | |||
| Open pressure | 159 kPa (23 psi) | ||
| Close pressure | 290 kPa (42 psi) | ||
| Refrigerant Lubricant | |||
| PAG Refrigerant Compressor Oil (R-134a Systems) YN-12-D | WSH-M1C231-B | ||
| Capacity | 207 ml (7 oz) | ||
| Refrigerant | |||
| R-134a Refrigerant YN-19 (US); CYN-16-P or CYN-16-R (Canada) | WSH-M17B19-A | ||
| Capacity | 0.77 kg (27 oz) | ||
| Refrigerant System Cleaner | |||
| A/C System Flushing Solvent YN-23 | - | ||
| Refrigerant System Coating | |||
| A/C Cooling Coil Coating YN-29 | - | ||
| Refrigerant System Dye | |||
| R-134a Leak Detection Dye 164-R6060 or 164-R6081 | - | ||
|
|||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.