Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 251 (STEERING SYSTEM-GENERAL INFORMATION)DIAGNOSIS AND TESTINGSTEERING SYSTEMNOTES
2010 Mercury Mariner Hybrid, AWD
Steering System: Notes
2010 Mercury Mariner Hybrid, AWDSECTION Notes
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
For the Crown Victoria refer to ELECTRONIC POWER STEERING for schematic and connector information.
For the Grand Marquis refer to ELECTRONIC POWER STEERING for schematic and connector information.
SPECIAL TOOL(S)
| Worldwide Diagnostic System (WDS) Vehicle Communication Module (VCM) with appropriate adapters, or equivalent diagnostic tool |
|
| Dial Thermometer 32°C-104°C (0-220°F) 023-R0007 or equivalent |
|
| 73III Automotive Meter 105-R0057 or equivalent |
|
| Flex Probe Kit 105-R025B |
|
| Power Steering Analyzer 211-F001 (014-00207) or equivalent |
|
| Gauge, Spring Tension 211-034 (T74P-3504-Y) |
|
| DIS/EDIS Tach Adapter 211-105 (T85M-3395-A) |
|
| Remover/Installer C-Frame and Screw 211-023 (T74P-3044-A1) |
MATERIAL SPECIFICATIONS
| Item | Specification |
|---|---|
| MERCON® Multi-Purpose ATF Transmission Fluid XT-2-QDX | MERCON® |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.