Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 151 (STEERING SYSTEM-GENERAL INFORMATION)SPECIFICATIONSGENERAL SPECIFICATIONS
2010 Mercury Mariner Hybrid, AWD
General Specifications
2010 Mercury Mariner Hybrid, AWDSECTION General Specifications
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Lubricants | |
| MERCON® Multi-Purpose (ATF) Transmission Fluid XT-2-QDX | MERCON® |
| Power Steering Gear | |
| Fluid capacity | 1.13 L (2.4 pt) |
| Turning effort | 2.27 kg (5 lb) |
| Turns lock-to-lock | 2.86 |
| Power Steering Purge Vacuum | |
| Vacuum | 68--85 kPa (20--25 in/Hg) |
| Power Steering Pump | |
| Flow | 9.42 liters/minute (2.48 gpm) Fluid @ 74°--80°C (165°--176°F) Engine at idle |
| Pressure | 414 kPa (60 psi) Fluid @ 74°--80°C (165°--176°F) Engine at idle |
| Minimum capacity | 4.33 liters/minute (1.14 gpm) Fluid @ 74°--80°C (165°--176°F) Engine at idle Pressure at 5,102 kPa (740 psi) |
| Relief pressure | 9,997--10,894 kPa (1,450--1,580 psi) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.