SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1445 (CLIMATE CONTROL SYSTEM)REMOVAL AND INSTALLATIONHEATING VENTILATION AIR CONDITIONING (HVAC) MODULE - FUSION, MILANREMOVAL AND INSTALLATION
2010 Mercury Mariner Hybrid, AWD

Removal and Installation

2010 Mercury Mariner Hybrid, AWDSECTION Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Vehicles equipped with navigation system 

  1. Remove the Front Display Interface Module (FDIM). For additional information, refer to INFORMATION & ENTERTAINMENT SYSTEMS -- FUSION, MILAN & MKZ article.
  2. Remove the 2 HVAC module screws.
  3. Disconnect the 2 HVAC module electrical connectors and remove the HVAC module.

    Vehicles without navigation system 

  4. Remove the center instrument panel finish panel. For additional information, refer to INSTRUMENT PANEL & CONSOLE -- FUSION, MILAN & MKZ article.
  5. Remove the 4 HVAC module screws and remove the HVAC module.

    All vehicles 

  6. To install, reverse the removal procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.