Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal and Installation
2010 Mercury Mariner Hybrid, AWDSECTION Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
It is not necessary to remove the Audio Control Module (ACM) to retrieve the part number. For additional information, REFER to FRONT DISPLAY INTERFACE MODULE (FDIM) - FUSION, MILAN or FRONT DISPLAY INTERFACE MODULE (FDIM) - MKZ in this service information.
- Upload the ACM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION -- FUSION MILAN & MKZ article.
- Remove the Front Controls Interface Module (FCIM). For additional information, REFER to FRONT CONTROLS INTERFACE MODULE (FCIM) - MKZ in this service information.
- Remove the 8 screws and the ACM.
- To install, reverse the removal procedure.
NOTE:
Module configuration is required when a new ACM is being installed.
- Download the ACM configuration information from the scan tool. For additional information, refer to PMI in MODULE CONFIGURATION -- FUSION MILAN & MKZ article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.