Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1416 (SUPPLEMENTAL RESTRAINT SYSTEM)GENERAL PROCEDURESPYROTECHNIC DEVICE DISPOSALDISPOSAL OF DEPLOYABLE DEVICES AND PYROTECHNIC DEVICES THAT ARE UNDEPLOYED/INOPERATIVE
2010 Mercury Mariner Hybrid, AWD
Disposal of Deployable Devices and Pyrotechnic Devices That are Undeployed/Inoperative
2010 Mercury Mariner Hybrid, AWDSECTION Disposal of Deployable Devices and Pyrotechnic Devices That are Undeployed/Inoperative
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
All inoperative air bag modules and safety belt pretensioners have been placed on the Mandatory Return List. All discolored or damaged air bag modules must be treated the same as any inoperative live air bag being returned.
- Depower the Supplemental Restraint System (SRS). For additional information, REFER to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING in the General Procedures portion of this service information.
- Remove the undeployed/inoperative device. For additional information, refer to the appropriate procedure in this service information or SAFETY BELT SYSTEM -- FUSION, MILAN & MKZ article.
- If installing a new air bag module, record the necessary information and return the inoperative air bag module to Ford Motor Company.
NOTE:
When installing a new air bag module, a prepaid return postcard is provided with the replacement air bag module. The serial number for the new part and the Vehicle Identification Number (VIN) must be recorded and sent to Ford Motor Company.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.