Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1380 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS AND DESCRIPTIONS (HYBRID))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P0222: THROTTLE/PEDAL POSITION SENSOR/SWITCH B CIRCUIT LOW
2010 Mercury Mariner Hybrid, AWD
DTC P0222: Throttle/Pedal Position Sensor/Switch B Circuit Low
2010 Mercury Mariner Hybrid, AWDSECTION DTC P0222: Throttle/Pedal Position Sensor/Switch B Circuit Low
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, 2011 Ford Fusion, 2010 Mercury Milan, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
P0222 - THROTTLE/PEDAL POSITION SENSOR/SWITCH B CIRCUIT LOW
| Description: | The electronic throttle control (ETC) throttle position (TP) sensor 2 circuit was flagged as a concern by the powertrain control module (PCM) indicating a low voltage, or open circuit. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | This concern exhibits a symptom of limited power. A TP2 parameter identification (PID) reading less than 0.25 volt with the ignition on, engine off or ignition on, engine running, indicates a concern is present. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST DV . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.