Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Neutral Profile Correction
In order for the misfire detection system to function properly, any mechanical inaccuracies in the crankshaft position (CKP) sensor must be learned by the PCM. This information is stored in non-volatile memory (NVM) in the PCM. It is not cleared when the keep alive memory (KAM) is reset.
Neutral profile learning is accomplished using the scan tool any time a PCM is replaced. It should also be relearned any time the CKP sensor is replaced or major engine repairs have been completed.
To determine if the neutral profile learning has been completed, check the MP_LRN parameter identification (PID) using the scan tool. The PID should read YES if the neutral profile learning has been completed. If the PID reads NO, complete the neutral profile learning prior to diagnosing any misfire DTCs.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.