TM6 DTC P0A2F: Check The Automatic Transaxle Fluid Level

2010 Mercury Mariner Hybrid, AWDSECTION TM6 DTC P0A2F: Check The Automatic Transaxle Fluid Level
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, 2011 Ford Fusion, 2010 Mercury Milan, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: A low automatic transaxle fluid level may cause an traction motor over temperature condition.

Is the transaxle fluid level correct?Β 

Yes No
GO to TM7Β . ADD the necessary fluid to obtain the correct fluid level.
Refer to the ELECTRONICALLY CONTROLLED CONTINUOUSLY VARIABLE TRANSMISSION (ECVT)
GO to TM8Β .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.