Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1312 (EXTERIOR LIGHTING SYSTEM)DESCRIPTION AND OPERATIONEXTERIOR LIGHTINGNOTES
2010 Mercury Mariner Hybrid, AWD
Exterior Lighting: Notes
2010 Mercury Mariner Hybrid, AWDSECTION Notes
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
The exterior lighting system consists of the following components:
- Headlamp assemblies
- Rear lamp assemblies
- Reversing lamps
- License plate lamp
- Front turn signal/cornering lamps (located in the headlamp assembly)
- High mounted stoplamp
- Light sensor (located under the center of the defroster grille panel)
- Multifunction switch
- Headlamp switch
- Stoplamp switch
- Ballast (HID headlamps only) (located in the headlamp assembly)
- Lighting control module (LCM) (located behind the LH instrument panel lower insulator rearward of the accelerator pedal)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.