SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1302 (HVAC - CLIMATE CONTROL SYSTEM - GENERAL INFORMATION AND DIAGNOSTICS)DESCRIPTION AND OPERATIONCLIMATE CONTROL SYSTEMSYSTEM AIRFLOWAUTO
2010 Mercury Mariner Hybrid, AWD

System Airflow: Auto

2010 Mercury Mariner Hybrid, AWDSECTION Auto
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

When AUTO is selected:

  • the temperature control setting(s) is manually set to the desired setting(s).
  • the air inlet door actuator is automatically controlled by the HVAC module, based on the temperature setting(s), but can be manually overridden by selecting the recirculation button.
  • the panel/defrost and floor door actuators are automatically controlled by the HVAC module based on the temperature setting(s), but can be manually overridden by selecting any of the air distribution buttons.
  • the A/C compressor is automatically controlled by the HVAC module based on the temperature setting(s), but can be manually overridden by selecting the A/C button. The A/C compressor will not operate if the outside temperature is lower than approximately 2°C (35°F).
  • the blower motor is on. The blower motor speed is automatically controlled by the HVAC module based on the temperature setting(s), but can be manually overridden by adjusting the blower speed rocker button.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.