Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1228 (SEAT SYSTEM - SEATS)REMOVAL AND INSTALLATIONDUAL CLIMATE CONTROLLED SEAT MODULE (DCSM)REMOVAL
2010 Mercury Mariner Hybrid, AWD
Dual Climate Controlled Seat Module (DCSM): Removal
2010 Mercury Mariner Hybrid, AWDSECTION Removal
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When installing a new Dual Climate Controlled Seat Module (DCSM), it is necessary to carry out the Programmable Module Installation (PMI) procedure. For additional information, refer to
MODULE CONFIGURATION
.
- Before removing the DCSM , carry out the appropriate steps in the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION .
- Remove the front passenger seat. For additional information, refer to SEAT - FRONT .
- Remove the DCSM from the cushion electrical bracket.
- Release the locking wedges and disconnect the 3 DCSM electrical connectors.
- Remove the 2 rivets and DCSM .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.