Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1224 (INFORMATION SYSTEM AND ENTERTAINMENT SYSTEM)REMOVAL AND INSTALLATIONFRONT DISPLAY INTERFACE MODULE (FDIM) - FUSION, MILANREMOVAL AND INSTALLATION
2010 Mercury Mariner Hybrid, AWD
Removal and Installation
2010 Mercury Mariner Hybrid, AWDSECTION Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Vehicles without navigation require Programmable Module Installation (PMI) when a new module is being installed. For vehicles without navigation, the Front Display Interface Module (FDIM) is not a stand-alone module.
- For vehicles without navigation, upload the FDIM configuration information to the scan tool. For additional information, refer to PMI in MODULE CONFIGURATION .
- Remove the instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
- Remove the 4 screws and the FDIM
.
- Disconnect the electrical connectors.NOTE: For vehicles with navigation, make sure not to bend the video cable when removing the FDIM .
- Disconnect the electrical connectors.
- To install, reverse the removal procedure.
- For vehicles without navigation, download the configuration information to the FDIM . For additional information, refer to PMI in MODULE CONFIGURATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.