Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1224 (INFORMATION SYSTEM AND ENTERTAINMENT SYSTEM)REMOVAL AND INSTALLATIONAUDIO DIGITAL SIGNAL PROCESSING (DSP) MODULEREMOVAL AND INSTALLATION
2010 Mercury Mariner Hybrid, AWD
Removal and Installation
2010 Mercury Mariner Hybrid, AWDSECTION Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This procedure applies to Fusion/Milan with Sony® sound and MKZ with THX® sound only. For all other amplifiers, refer to the appropriate procedure(s).
- Upload the audio DSP
module configuration information to the scan tool. For additional information, refer to PROGRAMMABLE MODULE INSTALLATION (PMI)
.NOTE: Module configuration is required when a new audio Digital Signal Processing (DSP) module is being installed.
- Remove the 4 pushpins and the RH luggage compartment trim panel.
- Disconnect the audio DSP module electrical connectors.
- Remove the 3 bolts and the audio DSP
module.
- To install, tighten to 9 Nm (80 lb-in).
- To install, reverse the removal procedure.
- Download the configuration information to the audio DSP module. For additional information, refer to PMI in MODULE CONFIGURATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.