Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1216 (ANTI-LOCK BRAKE SYSTEM - VEHICLE DYNAMIC SYSTEMS)DIAGNOSIS AND TESTINGANTI-LOCK CONTROL - HYBRIDDTC TABLESINSTRUMENT PANEL CLUSTER (IPC) DTC TABLE
2010 Mercury Mariner Hybrid, AWD
Instrument Panel Cluster (IPC) DTC Table
2010 Mercury Mariner Hybrid, AWDSECTION Instrument Panel Cluster (IPC) DTC Table
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This module utilizes a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens or shorts to ground. Continuous Memory Diagnostic Trouble Codes (CMDTCs) have an additional 2-character DTC status code suffix to assist in determining DTC history.
DTC DESCRIPTION TABLE
| DTC | Description | Source | Action |
|---|---|---|---|
| C0089:11 | TCS Disable Switch: Circuit Short to Ground | Instrument Panel Cluster (IPC) | Go To PINPOINT TEST AA . |
| - | All Other IPC DTCs | IPC | REFER to the Master DTC Chart in MULTIFUNCTION ELECTRONIC MODULES . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.