Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1106 (INTERIOR LIGHTING)
2010 Mercury Mariner Hybrid, AWD
Section 1106 (Interior Lighting)
2010 Mercury Mariner Hybrid, AWDSECTION Section 1106 (Interior Lighting)
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Diagnostic Tests
- Interior Lighting
- Notes
- Principles of Operation
- Inspection and Verification
- DTC Charts
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A: The Courtesy Lamps Are Inoperative
- Pinpoint Test B: The Courtesy Lamps Stay On Continuously
- Pinpoint Test C: An Individual Courtesy Lamp Is Inoperative
- Pinpoint Test D: The Courtesy Lamps Do Not Turn On With One Door Open
- Pinpoint Test E: An Individual Demand Lamp Is Inoperative
- Pinpoint Test F: The Battery Saver Does Not Deactivate After Time-Out
- Pinpoint Test G: The Illuminated Entry Is Inoperative When Using The Remote Transmitter
- Pinpoint Test H: The Demand Lighting Is Inoperative
- Pinpoint Test I: The Courtesy Lamps Are Inoperative From The Headlamp Switch
- Interior Lighting
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.