Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1095 (CLIMATE CONTROL SYSTEM - GENERAL INFORMATION AND DIAGNOSTICS)DESCRIPTION AND OPERATIONCLIMATE CONTROL SYSTEMSYSTEM AIRFLOW DESCRIPTIONVENT
2010 Mercury Mariner Hybrid, AWD
System Airflow Description: Vent
2010 Mercury Mariner Hybrid, AWDSECTION Vent
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
When VENT is selected:
- The recirculation air duct door is in the no vacuum position, blocking recirculated air and admitting outside air.
- The floor/panel door and the floor/defrost door are at the full vacuum position, directing airflow to the instrument panel A/C registers.
- The temperature can be adjusted to heat the air but air cannot be cooled below outside temperature.
- The A/C compressor will be disabled when VENT is selected.
- The blower motor is ON.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.