Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MARINER HYBRID, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1000 (SUSPENSION SYSTEM - GENERAL INFORMATION)SPECIFICATIONSGENERAL SPECIFICATIONS
2010 Mercury Mariner Hybrid, AWD
General Specifications
2010 Mercury Mariner Hybrid, AWDSECTION General Specifications
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Ball Joint Deflection | |
| Lower | 0-0.2 mm (0-0.008 in) |
| Front Ride Height | |
| All vehicles | 3.3 mm (0.13 in) ± 8 mm (0.31 in) |
| Rear Ride Height | |
| All vehicles except all wheel drive (AWD) | 94.8 mm (0.13 in) ± 8 mm (0.31 in) |
| Hybrid AWD vehicles | 88 mm (3.46 in) ± 8 mm (0.31 in) |
| Side-to-Side Lean (All Vehicles) | |
| Front | 0 mm (0 in) ± 10 mm (0.39 in) |
| Rear | 0 mm (0 in) ± 10 mm (0.39 in) |
| Tire Balance Weight | |
| Maximum balance weight (total of inner and outer wheel flange) | 140 g (5.0 oz) per wheel 70 g (2.5 oz) per flange |
| Tire Inflation | |
| Tires | See safety certification sticker on driver door jamb |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.