Stability/Traction Control Switch: Notes

2010 Mercury Mariner Hybrid, AWDSECTION Notes

The stability/traction control switch provides the driver with the ability to disable only the traction control feature. Anti-lock control, ESC  and RSC®  systems will remain functional. The switch is hardwired to the ABS module. When the stability/traction control switch is pressed, a ground signal is sent to the ABS module. The ABS module then sends a message over the HS-CAN  bus to the IC  indicating that the driver has requested that the system be deactivated and the IC illuminates the stability/traction control indicator (sliding-car icon). The ABS module and the PCM will then ignore any traction events until the driver presses the switch again or until the ignition key is cycled.

The AdvanceTrac® system cannot be disabled when a MyKey™-restricted key is in use that has the AdvanceTrac® always-on feature configured to "on". If an attempt is made to disable the AdvanceTrac® system while a MyKey™-restricted key is in use, ADVTRAC ON MYKEY SETTING will display in the IC  message center. For additional information about MyKey™, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) - HYBRID .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.