Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MOUNTAINEER 4.6 8, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 118 (HANDLES, LOCKS, LATCHES & ENTRY SYSTEMS)REMOVAL & INSTALLATIONHOOD LATCH RELEASE HANDLEREMOVAL & INSTALLATION
2009 Mercury Mountaineer 4.6 8, RWD
Removal & Installation
2009 Mercury Mountaineer 4.6 8, RWDSECTION Removal & Installation
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the LH fender splash shield. For additional information, refer to FRONT END BODY PANELS article.
- Remove the hood latch. For additional information, refer to Hood Latch .
- Release the hood latch release cable locators.
- Remove the bolt, the nut and the hood latch release handle and cable.
- To install, tighten to 5 Nm (44 lb-in).
- To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.