Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (MANUAL TRANSMISSION EXTERNAL CONTROLS SYSTEM)REMOVAL AND INSTALLATIONGEARSHIFT CABLESREMOVAL
2009 Mercury Milan Premier, 3.0 1, AWD
Gearshift Cables: Removal
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Removal
WARNING: This page is about a different variant/trim than selected.
- Remove the heater core and evaporator core housing. For additional information, refer to CLIMATE CONTROL article.
- Remove the battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
- Disconnect the gearshift cables from the shift mechanism.
- Pull the spring clip out of the groove. Lift upward to rotate the clip 90 degrees.
NOTE:
Carefully disconnect the spring clip, do not damage the spring clip.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.