Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (MANUAL TRANSMISSION)DISASSEMBLY AND ASSEMBLY OF SUBASSEMBLIESINPUT SHAFTNOTES
2009 Mercury Milan Premier, 3.0 1, AWD
Input Shaft: Notes
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Axle Bearing/Seal Plate | 205-090 (T75L-1165-B) | |
| Bearing Cone Replacer | 307-181 (T87C-77000-D) | |
| Bearing Cone Replacer | 308-155 (T88C-7025-DH) | |
| Bearing Puller | 205-D064 (D84L-1123-A) or equivalent | |
| Shaft Protector Set | 205-DS004 (D80L-625-A) or equivalent | |
| Dial Indicator Gauge with Holding Fixture | 100-002 (TOOL-4201-A) |
| Item | Part Number | Description |
|---|---|---|
| 1 | 7025 | Bearing |
| 2 | 7017 | Input shaft |
| 3 | 7B340 | 3rd gear |
| 4 | 7107 | Synchronizer blocking rings |
| 5 | - | Synchronizer hub assembly |
| 6 | 7109 | Synchronizer blocking springs |
| 7 | 7A044 | Synchronizer hub insert |
| 8 | 7105 | Synchronizer hub |
| 9 | 7106 | Synchronizer sleeve |
| 10 | 7064 | Snap ring |
| 11 | 7112 | 4th gear |
| 12 | 7025 | Bearing |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.