Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (ENGINE MECHANICAL - 2.3L)IN-VEHICLE SERVICINGTIMING DRIVE COMPONENTSINSTALLATION

2009 Mercury Milan Premier, 3.0 1, AWD

Timing Drive Components: Installation

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Installation

WARNING: This page is about a different variant/trim than selected.

Install the camshaft sprockets and the bolts. Do not tighten the bolts at this time.

Fig 1: Locating Camshaft Sprockets And Bolts

GF0028721

Courtesy of FORD MOTOR CO.

Install the timing chain guide and the 2 bolts.
- To install, tighten to 10 Nm (89 lb-in).

Fig 2: Identifying Bolts And LH Timing Chain Guide

G03897780

Courtesy of FORD MOTOR CO.

Install the timing chain.

Fig 3: Locating Timing Chain

GF0028718

Courtesy of FORD MOTOR CO.

Install the timing chain tensioner arm.

Fig 4: Locating RH Timing Chain Guide

G03897778

Courtesy of FORD MOTOR CO.

Install the timing chain tensioner and the 2 bolts. Remove the paper clip to release the piston.
- Tighten to 10 Nm (89 lb-in).

Fig 5: Locating Timing Chain Tensioner Bolts And Paper Clip

GF0024080

Courtesy of FORD MOTOR CO.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.