Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 980 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS AND DESCRIPTIONS (EXCEPT DIESEL & HYBRID))DTC DIAGNOSISP0689 - ELECTRONIC CONTROL MODULE (ECM)/POWERTRAIN CONTROL MODULE (PCM) POWER RELAY SENSE CIRCUIT LOW
2009 Mercury Milan Premier, 3.0 1, AWD
P0689 - Electronic Control Module (ECM)/Powertrain Control Module (Pcm) Power Relay Sense Circuit Low
2009 Mercury Milan Premier, 3.0 1, AWDSECTION P0689 - Electronic Control Module (ECM)/Powertrain Control Module (Pcm) Power Relay Sense Circuit Low
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2008 Mercury Sable, 2008 Mercury Mountaineer, 2008 Mercury Milan, 2008 Mercury Mariner, and 2008 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P0689 - ELECTRONIC CONTROL MODULE (ECM)/POWERTRAIN CONTROL MODULE (PCM) POWER RELAY SENSE CIRCUIT LOW
| Description: | This DTC sets when the passive anti theft system (PATS) system indicates the key is in ON or START position and the ignition switch position run (ISP-R) circuit indicates OFF, ACC, or LOCK position. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | Diagnose and repair all PATS DTCs first. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | refer to PINPOINT TEST B . | |||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.