Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 980 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS AND DESCRIPTIONS (EXCEPT DIESEL & HYBRID))DTC DIAGNOSISP060A - INTERNAL CONTROL MODULE MONITORING PROCESSOR PERFORMANCE
2009 Mercury Milan Premier, 3.0 1, AWD
P060A - Internal Control Module Monitoring Processor Performance
2009 Mercury Milan Premier, 3.0 1, AWDSECTION P060A - Internal Control Module Monitoring Processor Performance
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2008 Mercury Sable, 2008 Mercury Mountaineer, 2008 Mercury Milan, 2008 Mercury Mariner, and 2008 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P060A - INTERNAL CONTROL MODULE MONITORING PROCESSOR PERFORMANCE
| Description: | Indicates an error occurred in the powertrain control module (PCM). This DTC may set in combination with P2105. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | Verify the PCM is at the latest calibration level. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | - | - | refer to PINPOINT TEST QE . | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.