SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 968 (CRUISE CONTROL SYSTEM)DIAGNOSTIC TESTSSPEED CONTROLPINPOINT TESTSPINPOINT TEST G: FLASH CODE 2 - STOPLAMP SWITCH CIRCUIT FAILUREPINPOINT TEST G: FLASH CODE 2 - STOPLAMP SWITCH CIRCUIT FAILURE
2009 Mercury Milan Premier, 3.0 1, AWD

Pinpoint Test G: Flash Code 2 - STOPLAMP Switch Circuit Failure

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Pinpoint Test G: Flash Code 2 - STOPLAMP Switch Circuit Failure
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Use the correct probe adaptor(s) when making measurements. Failure to use the correct probe adaptor(s) may damage the connector.
  1. G1 CHECK THE STOPLAMP OPERATION 
    • Apply and release the brake pedal while observing the stoplamps.
    • Do the stoplamps operate correctly?  
    1. YES  : Go to  G2.
    2. NO  : REFER to EXTERIOR LIGHTING article.
  2. G2 CHECK THE STOPLAMP BULBS 
    • Check the stoplamps for the presence of aftermarket LED lights.
    • Are the correct stoplamp bulbs installed?  
    1. YES  : Go to  G3.
    2. NO  : INSTALL the correct stoplamp bulbs. TEST the system for normal operation.
  3. G3 CHECK CIRCUIT 511 (LG) FOR AN OPEN 
    • Disconnect: Speed Control Actuator C122
      • Fig 1: Checking Circuit For Open
      GF0025543Courtesy of FORD MOTOR CO.
    • While applying the brake pedal, measure the voltage between the speed control actuator C122-4, circuit 511 (LG), harness side and ground.
    • Is the voltage greater than 10 volts?  
    1. YES  : INSTALL a new speed control actuator. REFER to Speed Control Actuator . REPEAT the self-test.
    2. NO  : REPAIR the circuit. REPEAT the self-test.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.