Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 937 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REMOVAL AND INSTALLATIONFRONT IMPACT SEVERITY SENSORINSTALLATION
2009 Mercury Milan Premier, 3.0 1, AWD
Front Impact Severity Sensor: Installation
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Installation
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the electrical connector to the front impact severity sensor.
- Align the locator tabs of the front impact severity sensor to the openings in the radiator support bracket.
- Install the front impact severity sensor bolt.
- Tighten to 12 Nm (9 lb-ft).
- Install the radiator support bracket bolt.
- Tighten to 12 Nm (9 lb-ft).
- Attach the wiring harness pin-type retainers.
NOTE:
Make sure the radiator support and front impact severity sensor mating surfaces are clean and free of foreign material.
WARNING:
The tightening torque of the air bag front impact severity sensor retaining bolt is critical for correct system operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.