Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 930 (SAFETY BELT SYSTEM)DIAGNOSTIC TESTSSAFETY BELT SYSTEMCOMPONENT TESTFUNCTIONAL TEST - SYSTEM ROAD TEST INSPECTION
2009 Mercury Milan Premier, 3.0 1, AWD
Functional Test - System Road Test Inspection
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Functional Test - System Road Test Inspection
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Fasten the safety belts and proceed to a safe area.
- Attain a speed of 8 km/h (5 mph).
- Test the safety belts.
- Grasp the shoulder harness and prepare to lean forward.
WARNING: Apply maximum brake force only on dry concrete or equivalent hard surface, NEVER on wet pavement or gravel. Failure to follow this instruction may result in serious personal injury.
NOTE:
If the RH or the rear safety belts are to be tested, a passenger must be used.
WARNING:
The driver and passenger must be prepared to brace themselves in the event the safety belt retractor does not lock. Failure to follow this instruction may result in serious personal injury.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.