Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 865 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS AND DESCRIPTIONS - (HYBRID))DTC DIAGNOSISP2107 - THROTTLE ACTUATOR CONTROL (TAC) MODULE PROCESSOR
2009 Mercury Milan Premier, 3.0 1, AWD
P2107 - Throttle Actuator Control (TAC) Module Processor
2009 Mercury Milan Premier, 3.0 1, AWDSECTION P2107 - Throttle Actuator Control (TAC) Module Processor
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
P2107 - THROTTLE ACTUATOR CONTROL (TAC) MODULE PROCESSOR
| Description: | The electronic throttle control (ETC) area of the powertrain control module (PCM) failed the self-test. The concern could be the result of an incorrect throttle position (TP) command, or TAC motor wires shorted together. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | A TAC motor circuit PID reading may indicate a concern, if available. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | refer to PINPOINT TEST DV . | |||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.