SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 664 (INFORMATION AND MESSAGE CENTER)GENERAL PROCEDURESCOMPASS CALIBRATION
2009 Mercury Milan Premier, 3.0 1, AWD

Compass Calibration

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Compass Calibration
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: For optimum calibration, drive to an open, level location away from large metallic objects or structures. Switch off all non-essential electrical accessories (rear window defrost, heater A/C, map lamps, wipers, etc.) and make sure all doors are closed.
  1. Start the vehicle.
  2. Press the RESET button until RESET FOR CAL/INFO TO EXIT is displayed in the message center display.
    3. NOTE: This will take up to 3 circles to complete calibration
  3. Slowly drive the vehicle in a circle at no more than 5 km/h (3 mph) until SLOW CIRCLES TO CALIBRATE changes to CALIBRATION COMPLETED in the message center.
  4. The compass is now calibrated.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.