SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 629 (VEHICLE DYNAMIC SYSTEMS)DIAGNOSIS AND TESTINGANTI-LOCK CONTROLPINPOINT TESTSPINPOINT TEST A: NO COMMUNICATION WITH THE ANTI-LOCK BRAKE SYSTEM (ABS) MODULEPINPOINT TEST A: NO COMMUNICATION WITH THE ANTI-LOCK BRAKE SYSTEM (ABS) MODULE
2009 Mercury Milan Premier, 3.0 1, AWD

Pinpoint Test A: No Communication With The Anti-Lock Brake System (Abs) Module

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Pinpoint Test A: No Communication With The Anti-Lock Brake System (Abs) Module
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: The Flex Probe Kit must be used for all test connections. Use of standard multimeter probes may damage wiring terminals
  1. A1 CHECK THE ABS MODULE VOLTAGE SUPPLY CIRCUITS FOR AN OPEN 
    • Key in OFF position.
    • Disconnect: ABS Module C135.
    • Key in ON position.
    • Measure the voltage between ground and:
      • ABS module C135-1, SBB36 (GN/RD), harness side.
      • ABS module C135-8, CBP19 (BN/WH), harness side.
      • ABS module C135-32, SBB10 (YE/RD), harness side.
    • Are the voltages greater than 10 volts? 

    Yes  : GO to A2.

    No  : VERIFY SJB fuse 28 (10A) is OK. If OK, REPAIR circuit CBP19 (BN/WH) for an open.

    VERIFY BJB fuse 36 (40A) is OK. If OK, REPAIR circuit SBB36 (GN/RD) for an open.

    VERIFY BJB fuse 10 (20A) is OK. If OK, REPAIR circuit SBB10 (YE/RD) for an open.

    TEST the system for normal operation.

  2. A2 CHECK THE ABS MODULE GROUND CIRCUIT FOR AN OPEN 
    • Key in OFF position.
    • Measure the resistance between ABS module C135-16, circuit GD123 (BK/GY), harness side and ground.
    • Is the resistance less than 5 ohms? 

    Yes  : REFER to MODULE COMMUNICATIONS NETWORK to continue diagnosis of the communication network.

    No  : REPAIR circuit GD123 (BK/GY) for an open. TEST the system for normal operation.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.