SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 520 (POWER STEERING SYSTEM)REMOVAL AND INSTALLATIONINNER TIE RODINSTALLATION
2009 Mercury Milan Premier, 3.0 1, AWD

Inner Tie Rod: Installation

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Installation
WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Thoroughly remove any foreign material. This material is extremely harmful to the steering gear.
  1. Using the special tool, install the inner tie rod.
    • Tighten to 110 N.m (81 lb-ft).
    2. NOTE:
    1. Apply steering gear grease to the steering gear bellows grooves in the inner tie rod.
    2. Make sure the steering gear bellows is positioned correctly over the steering gear housing bead and the grooves in the inner tie rod.
    3. Make sure the steering gear bellows is not twisted and the breather tube (if equipped) is securely inserted into the breather nipple of the steering gear bellows.
  2. Position the inner tie-rod bellows clamp and install the bellows.
    3. NOTE:
    1. Using the special tool, install the inner bellows boot clamp.
    2. Make sure that the end of the steering gear bellows boot is positioned between the 2 grooves on the inner tie rod or an internal leak may result.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.