SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 390 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REMOVAL AND INSTALLATIONRESTRAINTS CONTROL MODULE (RCM)INSTALLATION
2009 Mercury Milan Premier, 3.0 1, AWD

Restraints Control Module (RCM): Installation

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: The tightening torque of the air bag RCM retaining bolts is critical for correct system operation.
  1. Position the RCM and install the 3 bolts.
    • Tighten to 11 Nm (8 lb-ft).
  2. Connect the small RCM electrical connector.
  3. Make sure the connector position assurance lever is in the full release position before attempting to connect the large RCM electrical connector.
    Fig 1: Identifying Connector Position Assurance Lever
    G04622828Courtesy of FORD MOTOR CO.
    4. CAUTION: Putting the large RCM electrical wiring connector into the RCM on an angle can cause bad electrical connections and damage components.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.