Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 312 (COMPONENT TESTING)COMPONENT TESTINGSEAT ADJUST SWITCH, DRIVER SIDE FRONT (14A701), WITHOUT POWER RECLINERCOMPONENT TESTING PROCEDURE
2009 Mercury Milan Premier, 3.0 1, AWD
Component Testing Procedure
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Component Testing Procedure
WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
SEAT ADJUST SWITCH, DRIVER SIDE FRONT (14A701), WITHOUT POWER RECLINER COMPONENT TESTING
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Power and Ground Checks Before Any Other Tests | 2 and 1, 3, 5, 6, 7, 8 | Rest | Closed circuit |
| 2 and 4 | Rest | Open circuit | |
| Tilt, front | 4 and 1 | Up | Closed circuit |
| 4 and 8 | Down | Closed circuit | |
| Tilt, rear | 4 and 5 | Up | Closed circuit |
| 4 and 6 | Down | Closed circuit | |
| Forward/rearward circuit | 4 and 3 | Forward | Closed circuit |
| 4 and 6 | Rearward | Closed circuit |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.