Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 300 (SEAT SYSTEM)SPECIFICATIONSTORQUE SPECIFICATIONS
2009 Mercury Milan Premier, 3.0 1, AWD
Torque Specifications
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Torque Specifications
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Front seat track-to-floor bolts | 25 | 18 | - |
| Front seat track-to-floor nut, outboard | 25 | 18 | - |
| Front seat track-to-floor nut, inboard | 80 | 59 | - |
| Front seat backrest pivot bolt | 45 | 33 | - |
| Seat recliner-to-backrest bolts | 27 | 20 | - |
| Seat power recliner-to-seat track bolts | 52 | 38 | - |
| Seat manual recliner-to-seat track bolts | 55 | 41 | - |
| Front seat safety belt buckle nut | 40 | 30 | - |
| Front seat safety belt buckle and belt tension sensor nut | 40 | 30 | - |
| Seat track-to-cushion frame bolts | 20 | 15 | - |
| Side air bag module nuts | 7 | - | 62 |
| Front seat armrest bracket bolts | 9 | - | 80 |
| Rear seat backrest nuts | 48 | 35 | - |
| Rear seat armrest bracket nuts | 5 | - | 44 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.