Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 266 (AUTOMATIC TRANSMISSION)DISASSEMBLYTRANSMISSION
2009 Mercury Milan Premier, 3.0 1, AWD
Section 266 (Automatic Transmission): Disassembly: Transmission
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Transmission
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL DESCRIPTION
| Slide Hammer 100-001 (T50T-100-A) |
|
| Holding Fixture, Transmission 307-003 (T57L-500-B) |
|
| Slide Hammer 307-005 (T59L-100-B) |
|
| Remover, Transmission Fluid Seal 307-048 (T74P-77248-A) |
|
| Handle, Torque Converter 307-091 (T81P-7902-C) |
|
| Remover, Transmission Fluid Pump 307-221 (T89T-70010-A) |
|
| Remover/Installer, Servo Piston 307-251 (T92P-70023-A) |
|
| Remover, Torque Converter Fluid Seal 307-309 (T94P-77001-BH) |
|
| Remover, Bearing Cup 308-047 (T77F-1102-A) |
- Using the special tools, remove torque converter.
- Using the special tool, mount the transmission to the bench.
NOTE:
If the transmission fluid pan gasket is not damaged, it may be reused.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.