Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 250 (ANTI-LOCK BRAKE SYSTEM)REMOVAL AND INSTALLATIONANTI-LOCK BRAKE SYSTEM (ABS) MODULEREMOVAL AND INSTALLATION

2009 Mercury Milan Premier, 3.0 1, AWD

Removal and Installation

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

Remove the air cleaner. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
Disconnect the anti-lock brake system (ABS) module electrical connector.
Disconnect the hydraulic control unit (HCU) pump motor electrical connector.

NOTE: Care must be taken when removing the module from the hydraulic control unit (HCU).

Remove the ABS module.
- Remove the screws in the sequence shown.
- To install, tighten to 3 Nm (27 lb-in).
  
  Fig 1: Identifying Removing Sequence Of Screws
  Courtesy of FORD MOTOR CO.

NOTE: Make sure that the ABS module-to-HCU gasket surfaces are clean and that the gasket is correctly installed.

To install, reverse the removal procedure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.