SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 211 (SAFETY BELT SYSTEM)DIAGNOSIS AND TESTINGSAFETY BELT SYSTEMFUNCTIONAL TESTSFUNCTIONAL TEST - SYSTEM ROAD TEST INSPECTION
2009 Mercury Milan Premier, 3.0 1, AWD

Functional Test - System Road Test Inspection

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Functional Test - System Road Test Inspection
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: If the RH or second and third rear safety belts are to be tested, a passenger must be used.
  1. Fasten the safety belts and proceed to a safe area.
  2. Attain a speed of 8 km/h (5 mph).
    3. WARNING: The driver and passenger must be prepared to brace themselves if the retractor does not lock.
  3. Test the safety belts.
    1. Grasp the shoulder harness and prepare to lean forward.
      2. WARNING: The maximum brake application should be on dry concrete or equivalent hard surface, NEVER on wet pavement or gravel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.