Compressor to Condenser Discharge Line - Hybrid: Notes

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Notes
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL SPECIFICATIONS

Item Specification
Motorcraft® Electric A/C Compressor Oil
YN-32
-
Fig 1: Compressor To Condenser Discharge Line Replacement Components With Torque Specifications - Hybrid
G06262771Courtesy of FORD MOTOR CO.
Item Part Number Description
1 W520413 Condenser inlet fitting nut
2 W701626 Lower rear A/C compressor bolt
3 W520413 A/C compressor discharge fitting nut
4 19D734 Compressor-to-condenser discharge line
5 19B596 Gasket seal (1 piece from kit required)
6 19B596 O-ring seal and gasket seal kit
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.