Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Traction Control Switch
Unlike conventional ABS, the traction control portion of the AdvanceTrac® can be deactivated by the driver through the use of the traction control switch. The switch is hardwired to the IPC. When pressed, the switch sends a ground signal to the IPC. The IPC then sends a message over the HS-CAN bus indicating that the driver has requested that the system be deactivated and illuminates the sliding-car OFF icon. Once disabled, the system remains in that state until the driver presses the switch again or the ignition key is cycled.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.