Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1758 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS AND DESCRIPTIONS (HYBRID))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC U0109: LOST COMMUNICATION WITH FUEL PUMP CONTROL MODULE
2009 Mercury Milan Premier, 3.0 1, AWD
DTC U0109: Lost Communication With Fuel Pump Control Module
2009 Mercury Milan Premier, 3.0 1, AWDSECTION DTC U0109: Lost Communication With Fuel Pump Control Module
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, 2011 Ford Fusion, 2010 Mercury Milan, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
U0109 - LOST COMMUNICATION WITH FUEL PUMP CONTROL MODULE
| Description: | The powertrain control module (PCM) monitors the fuel pump monitor (FPM) circuit for the presence of a duty cycled signal. If the FPM circuit is fixed at a low or high voltage, the PCM begins to increment a counter. The test fails when the PCM is still not detecting a duty cycled signal on the FPM circuit after a calibrated amount of time. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST KC . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.