SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1758 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS AND DESCRIPTIONS (HYBRID))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P062F: INTERNAL CONTROL MODULE EEPROM ERROR
2009 Mercury Milan Premier, 3.0 1, AWD

DTC P062F: Internal Control Module EEPROM Error

2009 Mercury Milan Premier, 3.0 1, AWDSECTION DTC P062F: Internal Control Module EEPROM Error
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, 2011 Ford Fusion, 2010 Mercury Milan, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
P062F - INTERNAL CONTROL MODULE EEPROM ERROR

Description:  Indicates the powertrain control module (PCM) electrically erasable programmable read only memory (EEPROM) has been corrupted.
Possible Causes: 
  • Module reprogramming
  • Aftermarket performance products
  • PCM
  • PCM Power Relay
  • PCM Power Relay PCMRC circuit open or short to ground
  • PCM Power Relay VPWR circuits open or short to voltage
  • PCM Power Relay PCMRC circuit open or short to ground
  • Corrosion or incorrect connection at the PCM terminals and wiring
Diagnostic Aids:  Check for aftermarket performance products.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST B .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.