Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1701 (ENGINE CONTROLS - ACCELERATION CONTROL SYSTEM)REMOVAL & INSTALLATIONACCELERATOR PEDAL AND BRACKETREMOVAL
2009 Mercury Milan Premier, 3.0 1, AWD
Accelerator Pedal and Bracket: Removal
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Removal
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the accelerator pedal sensor electrical connector.
- Disconnect the accelerator pedal motor electrical connector.
- Disconnect the accelerator pedal motor drive cable connector.
- Remove the 3 nuts and the accelerator pedal and bracket assembly.
NOTE:
To prevent setting DTCs, make sure the ignition switch is in the OFF position prior to disconnecting the accelerator pedal electrical connectors.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.