Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1680 (HVAC - CLIMATE CONTROL SYSTEM - GENERAL INFORMATION AND DIAGNOSTICS)DIAGNOSTIC TESTSCLIMATE CONTROL SYSTEMHVAC MODULE - RETRIEVE CONTINUOUS DTCS
2009 Mercury Milan Premier, 3.0 1, AWD
HVAC Module - Retrieve Continuous DTCs
2009 Mercury Milan Premier, 3.0 1, AWDSECTION HVAC Module - Retrieve Continuous DTCs
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- This function will display continuous (intermittent) codes and hard faults that occur during normal operation.
- To display continuous codes, press the OFF and FLOOR buttons simultaneously and then release and within 2 seconds press the RECIRC button.
- To exit the display of continuous codes, press the front DEFROST button. This will exit and clear all DTCs. Press any button except DEFROST to exit without clearing DTCs set before the last ignition cycle.
- Always exit continuous codes display before powering the system down (system turned off).
- Continuous DTCs are saved only after an ignition cycle.
- Continuous DTCs will be deleted after 80 ignition switch ON cycles after the intermittent condition occurs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.