SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1657 (CRUISE CONTROL SYSTEM)REMOVAL AND INSTALLATIONCRUISE CONTROL DEACTIVATOR SWITCHREMOVAL AND INSTALLATION
2009 Mercury Milan Premier, 3.0 1, AWD

Removal and Installation

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the electrical connector.
  2. Rotate the cruise control deactivator switch counterclockwise one-quarter turn.
  3. Remove the cruise control deactivator switch.
    4. NOTE: When installing the cruise control deactivator switch, it is automatically self-adjusting to the correct position. Do not pull up or push down on the pedal during installation. Initial installation of the cruise control deactivator switch allows for one adjustment. If additional adjustments are necessary, install a new switch.
  4. To install, reverse the removal procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.