Torque Specifications

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Torque Specifications
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
Center middle instrument panel finish panel screws 2 - 18
Floor console rear bolts 7 - 62
Floor console screws 2 - 18
Hood release handle bolt 6 - 53
Instrument panel center brace bolts 20 - 177
Instrument panel side bolts 11 - 97
Instrument panel upper cowl bolts 20 - 177
Parking brake release handle bolt 6 - 53
Selector lever assembly bolts 25 18 -
Steering column intermediate shaft-to-coupling bolt 63 46 -
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.