Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1606 (ANTI-LOCK BRAKE SYSTEM - VEHICLE DYNAMIC SYSTEMS)REMOVAL AND INSTALLATIONWHEEL SPEED SENSOR RING - FRONTINSTALLATION
2009 Mercury Milan Premier, 3.0 1, AWD
Wheel Speed Sensor Ring - Front: Installation
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
PART DESCRIPTION CHART
| Item | Part Number | Description |
|---|---|---|
| 1 | - | Screw (part of 205-393, Drive Pinion Flange Installer) |
| 2 | 206-060 | Wheel Speed Sensor Ring Installer |
| 3 | 206-084/1 | Wheel Speed Sensor Ring Installer |
| 4 | - | Sleeve (part of 205-495, Transmission Output Shaft Flange Installer) |
| 5 | - | Bearing (part of 205-495, Transmission Output Shaft Flange Installer) |
| 6 | - | Nut (part of 205-495, Transmission Output Shaft Flange Installer) |
| 7 | 2C182 | Wheel speed sensor ring |
- Install the new ABS wheel speed sensor ring and the tools on the halfshaft as shown in the previous illustration.
- Install the ABS wheel speed sensor ring to the dimension as shown.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.