Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 154 (AUTOMATIC TRANSMISSION EXTERNAL CONTROLS)REMOVAL AND INSTALLATIONSELECTOR LEVER BEZELINSTALLATION

2009 Mercury Milan Premier, 3.0 1, AWD

Selector Lever Bezel: Installation

2009 Mercury Milan Premier, 3.0 1, AWDSECTION Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.

Install the PRNDL bezel.
- Make sure that the 4 locking tabs are snapped in place.
  
  Fig 1: Installing PRNDL Bezel
  Courtesy of FORD MOTOR CO.
Connect the light bulb to the PRNDL bezel.

Fig 2: Connecting Light Bulb To PRNDL Bezel
Courtesy of FORD MOTOR CO.
Install the lower shift knob bezel.

Fig 3: Installing Lower Shift Knob Bezel
Courtesy of FORD MOTOR CO.
Install the shift knob and bolt.

Fig 4: Installing Shift Knob Bolt
Courtesy of FORD MOTOR CO.
Slide the lower shift knob bezel up and snap it into place.

Fig 5: Sliding Lower Shift Knob Bezel Up And Snap It Into Place
Courtesy of FORD MOTOR CO.
Install the upper console panel.

Fig 6: Installing Upper Console Panel
Courtesy of FORD MOTOR CO.
Install the PRNDL trim ring.

Fig 7: Installing PRNDL Trim Ring
Courtesy of FORD MOTOR CO.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.