Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Audio Signals
Audio signal flow varies greatly depending on vehicle content.
Stereo signals contain left and right channel information, and are used for most audio signals.
A mono signal is used for the microphone input to the APIM . The mono signal is also used for the voice prompts, the TTS feature, ring tones, and any audio received through a connected mobile phone. These audio signals are output from the APIM to the ACM . The mono and stereo outputs from the APIM utilize separate circuits.
A digital signal is used to transmit data from a media device connected through the USB port to the APIM . The APIM then converts the signal to analog and relays the signal to the ACM .
A wireless signal is used to broadcast audio signals from a Bluetooth device to the APIM . As with a digital signal sent through the USB port, the APIM converts the wireless audio signal to analog and relays it to the ACM .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.