Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1480 (MULTIFUNCTION ELECTRONIC MODULES)DIAGNOSIS AND TESTINGDRIVER SEAT MODULE (DSM)DTC CHARTS
2009 Mercury Milan Premier, 3.0 1, AWD
DTC Charts
2009 Mercury Milan Premier, 3.0 1, AWDSECTION DTC Charts
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
DRIVER SEAT MODULE (DSM) DTC TABLE
| DTC | Description | Action |
|---|---|---|
| B106E | Solid State Driver Disabled Due to Short Circuit | Go To PINPOINT TEST E . |
| B106F | Module Disabled Due to External Fault | Go To PINPOINT TEST E . |
| B1317 | Battery Voltage High | Go To PINPOINT TEST F . |
| B1318 | Battery Voltage Low | Go To PINPOINT TEST G . |
| B1342 | ECU is Faulted | CLEAR the DTCs. REPEAT the self-test. If DTC B1342 is retrieved again, INSTALL a new Driver Seat Module (DSM). REFER to Removal and Installation . TEST the system for normal operation. |
| B2477 | Module Configuration Failure | REFER to DTC TABLE . |
| U0140 | Lost Communication With Body Control Module (GEM ) | Go To PINPOINT TEST H . |
| U0155 | Lost Communication With Instrument Panel Cluster (IC ) Control Module | Go To PINPOINT TEST I . |
| U2050 | No Application Present | REFER to DTC TABLE . |
| All other DTCs | - | REFER to DIAGNOSTIC TROUBLE CODE (DTC) TABLE . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.